I wasn’t going to make a post about this, but I’m really proud of how it turned out and I haven’t posted anything on this site in ages. This post won’t be that detailed, though, so if you’re interested in a full how-to guide please leave a comment below! I made this to practice certain paper mache techniques so I can make a series of gifts for my friend Sophie (who’s designing a logo for my shop). The brief was “I want an incense burner, you know my aesthetic”. I decided to go with a woodland gothic theme, and always liked the idea of a tree with a face being used as a candle holder. I was really proud of it because it came out right the first time and there were only a few minor (and fairly rectifiable) mistakes. I hope it brings Sophie as much joy as it’s brought me!
I sometimes buy things not knowing what I’ll do with them. Case in point: An empty snow globe I bought at Hobbycraft a week before Halloween. I decided to leave it off to one side until I figure out what to do with it. Half a month later I was tidying up my shelves and figured I’d put it on my desk and see what I’d do with it. I’d been learning electronics for about a month and wanted to see what I could do with what I’d learned, so I went with a classic: A Christmas tree covered in snow, which flashes when I shake it. In the end the project failed, but as I always say: The cookie dough always tastes better than the cookie! So without further ado, the failed snow globe!
I’m not particularly proud of this one (not because it’s tacky, although it is), since this comes as the result of missing my dads birthday. I wanted to get him a really special gift so I decided to make him a model with what (at the time) little model building experience I had.
I made the hut using half a plastic Easter egg covered in coconut strands. I made the camp fire out of charred pieces of twig with shiny red and gold foil inside (I realize now that I should have done the red at the bottom and the gold at the top). The tree trunk and branches was made from coiled wire covered in paper, covered in latex that had been roughed up with a wire brush.The canopy was made from several fluffed up layers of scouring pads, covered in yellow foam powder. The grass was made using a static flock applicator with longer strands inserted manually (their tips were glued and dipped into brown foam powder). The ground was made from wet-painted SculptaMold then sprinkled with the dust from coconut husks to give the effect of fallen leaves. Finally the spade was made from a matchstick and lollipop stick painted brown and grey respectively, the edges of the head dry-brushed with terracotta paint giving a rusted effect.
Suffice to say I never forgot my dads birthday again. Happy Birthday Papa 🙂 ?
This is one of my earlier projects I did when I was bored. It was a snap decision and I had to learn to utilize what materials I had. I didn’t draw out a design, nor did I expressly plan anything. I just let the mood take me. I’m rather proud of the results. Click “Continue Reading” to see how I made it and what I could have improved.